| |
|
HT-1XS |
| Hot Tack Tester including heat sealing station |
| Heat seal applications are constantly evolving to meet the challenge of higher specification materials and faster productino methods. Determination of hot tack performance requires a test method that provides repeatable results, free of operator interference. The falling weight principle or the spring tests are difficult to regulate and are best suited for rough pass/ fail evaluations.
RDM's Hot Tack Tester HT-1XS provides an accurate, repeatable and consistent method of testing the sealing properties of a wide range of materials. It includes a precisely controlled heat sealing station. The sample is automatically pulled away from the sealing jaws in which the force required to separate the seal is then measured by a sensitive and accurate load cell. |
|
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
|
| Sealing jaws |
25 * 50 mm metal, aluminium or silicone rubber, flat or profiled |
|
| Sample strip |
25 * 330 mm |
|
| Load range |
0 - 1000 or 5000 grams |
|
| Pull speed |
600 mm/s |
|
| |
|
|
| |
|
|
|
|
| Christoph Zerwas / RDM / folien-papierpruefung |